How to test your water hardness
You need one number, total hardness in mg/L or grains per gallon. Here are three ways to get it, from free to most precise.
1. Read your utility's water quality report (free)
If you're on city water, your utility publishes an annual Consumer Confidence Report, and EPA keeps a finder for local reports. Look for "hardness" or "total hardness," usually in mg/L. If it isn't listed, call the utility and ask; it's a routine question. Remember that hardness can vary across a city with more than one water source. Details: find your city's water hardness.
2. Use test strips (a few dollars)
Total-hardness test strips change color in a few seconds and give a range in ppm or gpg. They're good enough to tell soft from very hard and to check whether a softener is working. Tips:
- Use a cold-water tap that isn't already softened (outdoor spigots are often unsoftened).
- Read the color at the time the instructions say. Late readings drift.
- Note the units on the chart and convert if needed (gpg = mg/L รท 17.1).
Strips are widely sold, for example on Amazon.
3. Independent lab test (most precise)
Private-well owners in particular should consider a lab test, which can also measure iron, which matters for softener sizing. Penn State Extension's advice: although many water softening companies offer free hardness testing, it's best to get a third-party evaluation; an independent lab test is not expensive and protects you from being oversold.
About the "free in-home water test"
Dealer demonstrations sometimes report results as levels or colors instead of numbers. Ask for the total hardness in mg/L or gpg and the iron level in writing, and compare with your utility report or a lab result before buying anything.
Next step
Got your number? Compare it to the hardness scale, then use the softener size calculator.